ISSN 1000-3665 CN 11-2202/P

    欠压密饱和黄土的失水敏感特性

    Dewater sensitivity of under-compacted saturated loess

    • 摘要: 非饱和黄土遇水后可能形成大孔隙结构仍然存在的欠压密饱和黄土,一旦失水或者减湿,变形会大幅度突增,对工程周边环境带来极大威胁,其核心原因是对饱和黄土特殊的水敏特性了解不清。以西安兴庆湖和曲江南湖周边的饱和黄土为研究对象,通过物性指标统计、分析及微观结构测试,得到了欠压密饱和黄土的基本物理性质;开展了6个降水工程的现场监测及室内外试验,提出欠压密饱和黄土的失水敏感性,研究欠压密饱和黄土地层失水变形敏感特性和失水强度敏感特性。(1)欠压密饱和黄土具有大孔隙比、中高压缩性的物理力学特征,普遍处于软塑或流塑状态,具有持续压密的空间基础和演化趋势;(2)欠压密饱和黄土地层实测地表沉降可达245.8 mm,土层单米失水变形量为2.09~10.65 mm/m;最大地面沉降速率可达4.5 mm/d,平均沉降速率为0.65~1.14 mm/d;(3)欠压密饱和Qp3黄土失水变形稳定速度快,快速变形持续时间约30 d;欠压密饱和Qp2黄土失水变形稳定速度慢,地表变形稳定时间普遍大于150 d。欠压密饱和黄土孔隙比越大、液性指数越大,土体单米失水变形量越大,沉降速率越快,即失水变形敏感性越强。欠压密饱和Qp3黄土失水过程中强度增长速度较快,增幅比例高,即失水强度敏感性强;欠压密饱和Qp2黄土水分疏干难度大,增长速度慢,即失水强度敏感性弱。研究成果是对黄土水敏性理论的丰富和发展,可为类似地层地下水控制工程的风险评价和应对提供理论依据。

       

      Abstract: Upon contact with water, unsaturated loess may transform into under-compacted saturated loess while retaining its large pore structure. During the process of water loss or moisture reduction, the soil will undergo sudden and substantial deformation, posing significant risks to the surrounding environment of the project. The fundamental challenge lies in an inadequate understanding of the unique water-sensitive properties of saturated loess. This study proposes the dewater sensitivity of under-compacted saturated loess. Focusing on the saturated loess around Xingqing Lake and Qujiang Nanhu in Xi'an, by statistical analysis of physical properties indicators, and pore structure testing, the basic properties of under-compacted saturated loess were obtained. Field monitoring and combined laboratory–field experiments from six pumping projects were then used to investigate the deformation and strength sensitivity associated with dewatering. The results show that under-compacted saturated loess presents large void ratio and medium to high compressibility. It is generally in a soft plastic or flow plastic state and has a spatial basis and evolutionary trend of continuous compaction. Under-compacted saturated loess has a strong sensitivity to dewatering deformation, which can be observed in its measured surface settlement of 245.8 mm. A single meter drop in water level can cause soil layer deformation of 2.09-10.65mm/m; the maximum settlement rate can reach 4.5mm/d, with average rate of 0.65-1.14mm/d. The larger the void ratio and liquid index, the larger the deformation of water loss per meter of soil and the faster the settlement rate, indicating a stronger sensitivity to dewatering deformation. Under-compacted saturated Qp3eol loess presents rapid rate of water loss deformation to be steady and short duration, with a stable state after approximately 30 days; whereas the steady-rate of water loss deformation of under-compacted saturated Qp2eol loess is slow, and the continuous deformation time on the surface is long, generally longer than 150 days. During dewatering. Qp3eol loess demonstrates rapid and substantial strength gain, indicating high strength sensitivity; by contrast, Qp2eol drains poorly, shows slow strength development, and shows relatively low strength sensitivity. This study advances the understanding of water-sensitive behavior in loess and provides a theoretical basis for risk assessment and mitigation strategies in groundwater-control engineering within similar geological settings.

       

    /

    返回文章
    返回